French Bulldog Quicksand Decoration Figurine
$53.99$79.99Save $26.00
Color:
Product description
Rotate the quicksand painting 180 degrees, allowing air to flow through the entire bottom of the quicksand, and you can enjoy the charming scene formed by the falling quicksand. Because bubbles and quicksand are randomly changing, each scene is different and will not repeat two identical scenes. For better results, when the quicksand completely settles to the bottom, keep it still for 30 minutes, and then flip it again.
Maintenance and air conditioning of quicksand art: With changes in temperature and pressure, sometimes you may need to adjust the air and water inside the quicksand painting. The packaging of the quicksand table lamp is equipped with an air conditioner (i.e. syringe), and there are air conditioning holes (circular air conditioning holes) at the top or both sides of each quicksand painting, which can be maintained by oneself.
Specific operation: The art of quicksand is the natural balance of water, sand, and air. A height of approximately 1cm is suitable for the air layer, and sand will achieve a relatively good flow velocity.
Attention: The air layer has been adjusted and balanced before shipment, and generally there is no need to adjust the air and water.
Precautions when inserting air holes:
The air hole is located between two pieces of glass, with a diameter of approximately 1mm. If a hard object cannot be inserted during insertion, it indicates that the air hole has not been inserted. Do not forcefully insert it at this time, as it may cause deformation of the regulator needle. You can choose a suitable position to retest until the regulator can be easily inserted.
Quicksand falling too slowly: extract some air
1. There is a hole at the top or side of the frame of each quicksand art, which concentrates air into any corner of the air hole and waits for the sand to move away.
2. Insert the regulator into the air hole and extract some air.
1. There is a hole at the top or side of the frame of each quicksand art, which concentrates air into any corner of the air hole and waits for the sand to move away.
2. Insert the regulator into the air hole and extract some air.
Quicksand falling too fast: add some air
1. Using the same method as above, concentrate the air at any corner of the air hole to determine the movement of sand
2. Insert the regulator into the air hole and add some air.
1. Using the same method as above, concentrate the air at any corner of the air hole to determine the movement of sand
2. Insert the regulator into the air hole and add some air.
If many small bubbles in the quicksand layer become extremely large bubbles, a little water can be filled to supplement the evaporation of water.
1. Be sure to use pure water or boiled water for cooling.
2. Select a vent, wait for the sand to move, remove some air, and empty the air syringe tube
3. Use an air syringe to pump in and add an equal amount of purified water
Be careful not to add too much water at once to prevent excessive pressure from causing glass breakage.
Return & Warranty
If you're not fully satisfied, please fill in our contact us form and we'll quickly work to correct the problem.